B2500 on 2010 FORD Ranger

“Nothing serious, but within the last year or so I had noticed that the front bumper, although it looks fine, is sagging a little on the sides. The front looks ok, but as it wraps around the sides, the ends tend to angle down.”

“I'm looking to get some wheels (17 or 18 not sure yet) exhaust, tint, lower it a bit and a nice sound system. This will be my first time lowering a truck (normally I lift them) so I will have some questions.”

“Same Here I've got a 1998 B2500 manual too with 145Km on it. It is what I learned stick on and I've always assumed that it wasn't letting me shift down because it was 'speed regulated.' (So I couldn't jam it into first when I was going to fast)”

“I have a 2001 B2500 that I got into a little fender bender with a while back. Nothing serious, but within the last year or so I had noticed that the front bumper, although it looks fine, is sagging a little on the sides.”

“I just got a B2500 SE its bone stock except for a rack for my bicycle. I'm looking to get some wheels (17 or 18 not sure yet) exhaust, tint, lower it a bit and a nice sound system.”

“It's just when I'm on a level surface. Also worth noting, I've been checking the clutch master cylinder reservoir for any fluid loss, still at the same level (hasn't lost any of the course of the week).”

“I went and checked it (I've owned it a week now) and it has lost about 1/4" in the reservoir. It's not leaking any coolant externally (none dripping on the ground).”

“It is what I learned stick on and I've always assumed that it wasn't letting me shift down because it was 'speed regulated.' (So I couldn't jam it into first when I was going to fast)”

“1998 b2500 2wd short bed My bed is rusted out pretty bad, can`t find decent replacement bed at bone yards.”

“My bed is rusted out pretty bad, can`t find decent replacement bed at bone yards. Many ranger beds available.”