Live Data
Last reported case: 4 years ago
Based on 5 owner reports, 5 from forums)
🚗P1009 on 2010 HONDA Accord
This page focuses specifically on P1009 issues reported by 2010 HONDA Accord owners. The experiences and fixes below are from real owners of this exact vehicle.
Symptoms Reported by 2010 HONDA Accord Owners:
check engine lightgrinding noiserough idlestallingtiming chain rattle
Parts Often Involved:
batterybattery traybelt tensionerengine bayfiltergarden hosegas caplock actuatormaf sensormotor mountoiloil screensorifice tubepower steering pumpseal ringshifter cablespark plugsstarter solenoidtensionerthrottle bodytiming chaintiming valvesvtc valvevtec valve
What Owners Say
Real experiences from 2010 HONDA Accord owners
Fixed Itvia forum_post
“I was 2000 miles into this oil change so that was not my first go to, but it ended up being the only issue for me!. Don't know if I was working it too hard in the snow over the past few months or if there's a bigger issue (I know these K-series engines like to burn thru oil anyways) but I was low a couple quarts so I topped her off and it immediately fixed the code; hasn't come on for the last 50 miles or so.”View original
Fixed Itvia forum_post
“Don't know if I was working it too hard in the snow over the past few months or if there's a bigger issue (I know these K-series engines like to burn thru oil anyways) but I was low a couple quarts so I topped her off and it immediately fixed the code; hasn't come on for the last 50 miles or so.”View original
Fixed Itvia forum_post
“When he held it at 2000 rpm in neutral it was fine. I cleared the code and the car does not have the typical timing chain rattle and the check engine light did not come back on, but the cars been parked since this happened on Sunday night.”View original
Warningvia forum_post
“Driving the car the other day and my check engine light, VSC light and the traction control warning light all came on. Continued to drive the car (not much of a choice, had to go to work) and eventually the VSC light and traction control warning light went off.”View original
Warningvia forum_post
“I own a 2008 Honda Accord LX with approximately 160k miles on it. Driving the car the other day and my check engine light, VSC light and the traction control warning light all came on.”View original
Experiencevia forum_reply
“I charged it up and popped it back in. Upon starting the car, I get a bit of a rough idle and then out of nowhere it rev's itself up from normal idle at about 1k to almost 3k(cable and throttle don't seem to move when this happens).”View original
Fixed Itvia forum_post
“I cleared the code and the car does not have the typical timing chain rattle and the check engine light did not come back on, but the cars been parked since this happened on Sunday night.”View original
Experiencevia forum_reply
“Hi Folks, Car in question is an 2005 4 Cylinder MT - this is a bit of a repost because I didn't make much headway in my prior post. I posted here about a month ago and I've been through a couple of diagnosis to try and find a solution to the problem I'm having which is still an issue.”View original
Experiencevia forum_post
“Problem is it doesn't make the characteristic grinding noise, and the car drives absolutely fine. If it is the actuator, will it harm the car to drive it around for a bit until I can change it?”View original
Experiencevia forum_post
“P1009 code, What should the resistance be on the VVT Solenoid? Hello, I have a 2004 2.4 Accord.”View original
These are real experiences shared by 2010 HONDA Accord owners on automotive forums and communities. Results may vary based on vehicle condition and repair quality.
About This Data
This page aggregates 5 discussions about P1009 from 2010 HONDA Accord owners across automotive communities.
Success rate (40%) is calculated from posts where owners confirmed whether their fix resolved the issue.
Last updated: 12/31/2021